Kitchen cabinet painting jobs require a variety of steps and skills. It is best to get cabinet restoration service if you find that you are not skilled in performing all of these tasks or do not have enough time to perform them. Whether you hire a professional crew or do it yourself, getting your kitchen cabinetry painted is a very satisfying experience. Before the paint arrives, the job must be covered with quality cabinet repair supplies to make sure that the paint will adhere properly and look good once it is applied. By reading this article you will learn how:
First, you need to prepare all areas that will be treated with stain. You need to clean and wipe all counters, backsplash walls, floors, and any other surface used to treat cabinet painting surfaces. In this next article you will learn exactly how to install, mask, and prime the kitchen cabinet surfaces, prepare the surface for stain, tools and supplies, preparation of the cabinet cabinets themselves for paint, dust removal, primer and finish coats, and final clean up. After cabinet painting is complete, you should use a cabinet restorative paste or sealant to help prevent staining. These products can be purchased at any home improvement store.
After you have cleaned and masked the surfaces of your cabinet painting, it is time to apply the stain. When applying the stain, it is important to follow the instructions on the can. Make sure that you cover the entire surface, especially the area around all hinges and doors. Apply the stain using a rag, then apply the top coat in even strokes. Wait for the stain to dry before removing it with a brush or sponge.
After the entire surface has been treated, you are ready to prime and paint the remaining portions of the cabinet doors. Prime the surface with a good quality wood primer, applying it to both sides of the doors and then using a hard wood roller to fill in any bare areas. Make sure that your primer is fully dried before you apply the topcoat, as well as to protect the existing cabinets from stains caused by moisture.
The new finish coats are applied to the surface in even strokes. It is important that you allow each coat to dry thoroughly between coats, which may include sanding the cabinet surfaces in order to get rid of any imperfections. Once the new finish coat is dry, you are ready to apply the trim around your cabinets. Trim the existing cabinets until you achieve the same new look, then sand the trim flush with the surrounding wood.
To avoid possible problems with the newly painted cabinets, make sure that you use only high quality wood that can stand the test of time. If you’re planning to do a refacing job, using substandard cabinet painting materials will most likely result in damage to the existing cabinets and an undesirable look for the finished room. The best thing about refinishing or refacing cabinets is that they’re relatively easy projects for a do-it-yourselfer to undertake. However, it is also important to remember that the quality of the materials you use will determine the final outcome. Using low quality materials will produce a cabin that has a worn appearance over time, while using very good materials will give you a beautifully new look for little effort. To learn more visit www.louisvillecabinetrefinishingandrefacing.com.